Modified Sine Wave Power Inverter 1000W

 

Output socket:

Features:
1)Input protections: Polarity reverse / Over and under voltage / Low battery Alarm and shut down
2)Output protections: Short circuit / Overload / Over temperature
3)With power ON/OFF switch and LED indicator
4)Input and output fully isolation
5)Low power consumption(standby)
6)LVD meet EN60950 and E8 mark
7)EMC meet EN61000-6-1-3,EN55022

Specifications:
 - Model: CAR1K 
 - Weight: 2600g 
 - Dimension/CTN./Pcs: 6636.536.5cm / 9pcs
 - Max. continuous output power: 1000W
 - Max. continuous output power 2H.: 1100W
 - Surge capability peak output power: 2000W
 - DC input static current (no load): 1.5AMP
 - AC output wave form: Modified Sine wave
 - Normal input voltage range: 11-15V / 21-30V
 - High voltage cut off level: 15V / 30V
 - Low voltage alarm: 10.6V±0.3V(DC12V) / 20.5V0.5V(DC24V)
 - Low voltage cut off level: 9.5V0.5V(DC12V) / 19.5V0.5V(DC24V)
 - Output AC voltage: AC 115V5% RMS / AC 230V 5% RMS 
 - Output frequency level: 60HZ1Hz / 50HZ
 - Overload power range: 1000W, 5-30% 
 - Hi-pot test: PRI/sec, 1500V/AC 5mA/60s
 - Temperature protection: 65
 - Full load max. optimum efficiency: 90%
 - AC output short circuit protection: system shut down (no damage)
 - Fan run: inner temperature rising up is 40
 - Fault warning: alarm beep
 - LED indicator:
        a) Normal: green 
        b) Fault: red green
 - Fuse (spade type): 40A4pcs
 - Dimensions (LWH): 27517677mm
 - Environmental condition:
        a) Operating temperature: -545
        b) Operating relative humidity: 10-90% RH 
        c) Storage temperature: -1050
        d) Storage relative humidity: 10-95% RH

Ask one question about this products

---

Previous Page: Modified Sine Wave Power Inverter 900W
Next Page: Modified Sine Wave Power Inverter 1200W